देखें। समझें। उगाएँ।MushroomWale और DMR सोलन की संयुक्त शैक्षिक पहल ↗
MushroomFarming.in

एक संयुक्त शैक्षिक पहल

MushroomWale.com
ICAR–खुम्ब अनुसंधान निदेशालय, सोलन का लोगोICAR–DMRसोलन
विषय
पाठ 5 / 18 · Button Mushroom Grower

कम्पोस्ट का द्वितीय चरण

द्वितीय चरण में कम्पोस्ट को 58 से 59 डिग्री पर पाश्चुरीकृत करके 45 से 48 डिग्री पर तब तक कंडीशन किया जाता है जब तक अमोनिया 10 पीपीएम से नीचे न आ जाए।

  • By the end you can separate pasteurisation, conditioning and cooling.
  • By the end you can state ICAR-DMR's bands and the two limits that must not be crossed.
  • By the end you can describe finished Phase II compost and why release depends on ammonia.

कम्पोस्ट का तापमान, दिन 0 से स्पॉनिंग तक

लंबी विधि की ढेरी 65 से 70 °C, फिर पाश्चुरीकरण 58 से 59 °C (4 से 6 घंटे), कंडीशनिंग 45 से 52 °C, स्पॉनिंग 25 से 30 °C। स्रोत: ICAR-DMR मैनुअल 2011।

30°40°50°60°70°80°पलटाईपलटाईपलटाईफेज़ I: बाहर की ढेरी, 65 से 70 °Cफेज़ II: 58 °C फिर 45 से 52 °Cस्पॉन 25 से 30 °Cदिन 0दिन 22
फेज़ I ढेरीफेज़ II सुरंगपाश्चुरीकरण

ये आंकड़े संबंधित स्रोत और विधि के संदर्भ में हैं। इन्हें हर प्रजाति या फार्म का सार्वभौमिक निर्देश न मानें। पुराने मूल्य वर्तमान बाज़ार भाव नहीं हैं।

Pre-pasteurisation conditioning45-52°C for 2 daysAfter levelling the mass to 45 to 48 °C.स्रोत: ICAR-DMR manual, 2011
Pasteurisation58-59°C for 4 to 6 hoursNever above 60 °C.स्रोत: ICAR-DMR manual, 2011
Post-pasteurisation conditioning45-48°C for 3 to 4 daysUntil ammonia is under 10 ppm, never below 40 °C.स्रोत: ICAR-DMR manual, 2011
Compost temperature at spawning25-30°CWith 64 to 66 percent moisture.स्रोत: ICAR-DMR manual, 2011
Conceptual cutaway of a compost conditioning tunnel with material above an air plenum.
AI-generated teaching illustration · not field evidence
Connect the picture to the lesson

Understand the tunnel

Notice
Air must pass through the loaded material.
Understand
Pasteurisation, conditioning and cooling have distinct purposes.
Try it
Use the validated process and release criteria, not an odour test.
See where this fits in the full workflow →

01Three jobs in one tunnel

Phase II is called pasteurisation, but that is only its middle act. First comes pre-pasteurisation conditioning: the compost is levelled to a uniform 45 to 48 °C and held in the 45 to 52 °C band for two days. Then pasteurisation, a short controlled peak that kills insects, nematodes and competitor spores. Then post-pasteurisation conditioning, back to 45 to 48 °C until the ammonia is gone.

Run the tunnel as one long hot period instead and you get compost that is clean but still full of ammonia, and the spawn dies in it.

02The peak and its ceiling

ICAR-DMR finds compost properly pasteurised when it is held at 58 to 59 °C for 4 to 6 hours. It is not pushed there suddenly: the temperature climbs at about 1 °C per hour, reaching the target in 10 to 12 hours largely from the compost's own heat.

The ceiling is hard. Above 60 °C, ICAR-DMR says, all organisms are killed including the thermophilic fungi Phase II depends on, and the same manual names that as a cause of olive green mould. A tunnel needs a compost probe, not an air thermometer by the door.

03Conditioning: where the ammonia goes

After the peak the compost is brought down at about 1.5 °C per hour and held at 45 to 48 °C. Surviving heat-loving fungi turn free ammonia into their own bodies, which the mushroom later eats. This step is what makes the compost selective. ICAR-DMR says it takes 3 to 4 days in a modern tunnel, or until the compost is free of ammonia.

Two limits protect it. Never condition below 40 °C, because mesophilic fungi set in and spoil the compost. Keep oxygen above 10 percent, since the fan is not optional.

04Uniformity, then evidence

A tunnel is filled 2 to 2.2 metres deep at about 900 to 1000 kg per square metre, with air pushed up from the plenum below. ICAR-DMR insists that the air above the compost, the compost itself and the plenum differ by no more than 3 °C, or one layer is under-pasteurised while another is over-cooked. On a small farm, probe a covered heap top, middle and bottom.

Finished compost has ammonia below 10 ppm, moisture around 64 to 66 percent with no liquid oozing when squeezed firmly, and a dark crumbly texture.

Plot a Phase II curve and mark the release gate

  1. Draw hours across and 20 to 65 °C up, shade 45 to 52 and 58 to 59, and rule a red line at 60.
  2. Log the compost probe every 2 hours and plot it.
  3. During conditioning, record validated ammonia measurements and the process observations specified by the trained operator. Never use deliberate smelling as a release test.
  4. Mark release only when the validated temperature, conditioning, ammonia and material acceptance criteria have all been met and recorded.

डायरी में लिखें: Compost temperature log, validated ammonia results, moisture assessment and the authorised release decision.

ये गलतियां न करें

  • Running one long cycle above 60 °C, which leaves ammonia in a dead compost.
  • Trusting the air sensor by the door while the compost core sits degrees away.
  • Releasing on the planned day while the compost still smells of ammonia.

खुद को जांचें

तीन सवाल, तुरंत जवाब

  1. The probe reads 62 °C for three hours during pasteurisation. What has happened?

  2. Conditioning is held at 38 °C to save fuel. Why is that a problem?

  3. Which observation releases compost from Phase II?

यह संपादकीय स्व-जांच है, प्रमाणपत्र नहीं। जवाब इस डिवाइस पर भी सहेजे नहीं जाते।

शब्दावली

Pasteurisation
A controlled heat peak that kills pests and competitor spores.
Conditioning
Holding compost at 45 to 48 °C so microbes remove ammonia.
Plenum
The air space under the tunnel floor through which the fan pushes air.
संदर्भ और आगे पढ़ें
Button mushroom cultivation and climate knowledge

Operating values require stage, strain, sensor and production-system context.

संदर्भ खोलें
इस पाठ का गाइडगाइड खोलें